Full Description

1.1 This test method covers the analysis of cannabinoids in cannabis products by gas chromatography (GC) and flame ionization detection (FID). 1.2 This test method is applicable to cannabis raw materials and resin cannabis products as defined in Guide D8245, including those from hemp. Such material includes: biomass; plant material; flowers; resins; extracts; distillates; recovered solvents; and other intermediate processing material. The applicable concentration range of analysis will vary to some extent depending on the nature of the sample, for instance measurement of delta-9-tetrahydrocannabinol (Δ⁹-THC) for regulatory purposes in hemp would require calibration to lower concentration levels compared to measurement of CBD in its isolate; however, in most cases, the test method is applicable to the determination of major and minor cannabinoids above about 0.1 mass% in concentration. Dilution of sample solutions is used to adjust concentrations to fall within appropriate calibration curves. Particular emphasis is placed on the determination of Δ⁹-THC for regulatory compliance purposes and control. This test method can measure any cannabinoid that is eluted and detected from a GC column with sufficient resolution from any interfering compounds. Typical cannabinoids of interest that can be determined by this test method are shown in Table 1. Use of an HPLC technique is recommended if individual measurement of acids, such as THCA, is required. 1.3 The test method does not purport to identify all individual cannabinoids; however, individual users can adapt this test method for specific custom analyses to meet their needs. 1.4 Units-Values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Product Details

Published: 07/15/2022 Number of Pages: 7 File Size: 1 file , 130 KB Note: This product is unavailable in Russia, Ukraine, Belarus